WASHINGTON, July 30 (Reuters) - The United States is suspending a “de minimis” exemption that allowed low-value commercial shipments to be shipped to the United States without facing tariffs, the White House said on Wednesday.

Under an executive order signed by President Donald Trump, packages valued at or under $800 sent to the U.S. outside of the international postal network will now face “all applicable duties” starting on August 29, the White House said.

  • AreaKode@lemmy.world
    link
    fedilink
    arrow-up
    29
    ·
    6 days ago

    Just got fucked by DHL holding my PCB order hostage. Had to pay an extra $66 that wasn’t at play last week, when I placed my order. I’m sooo glad the “country” is getting rich off of my back. I guess this is another hobby that will have to take a back seat for a few years…

    • Brkdncr@lemmy.world
      link
      fedilink
      arrow-up
      12
      ·
      6 days ago

      Some custom designed stuff I ordered just landed today. I’m about to pay an extra $300 because of that fool.

    • SpaceNoodle@lemmy.world
      link
      fedilink
      arrow-up
      12
      ·
      6 days ago

      I’ve been researching methods for fabbing my own boards. I’ve got some pretty tight tolerances I’m trying to meet.

        • SpaceNoodle@lemmy.world
          link
          fedilink
          arrow-up
          5
          ·
          edit-2
          6 days ago

          For my purposes: CNC routing is too sloppy. Photolithography is promising, but involves a lot of steps with potential for error at every stage, not to mention the chemicals necessary for etching. Lasers are interesting, both for lithography and direct copper ablation, but there’s a high barrier to entry with cost.

          • AtHeartEngineer@lemmy.world
            link
            fedilink
            English
            arrow-up
            2
            ·
            6 days ago

            Fair, ya even around 10 mil is probably pretty tough with a reasonable cost cnc. I imagine with laser ablation, you’ll probably run into similar issues, you still have to physically move and point the laser, mirrors, or your target base.

            I’ve got a little bit of a background in optics and sensors, but diy photolithography still seems pretty challenging, would be interested in following your work if you go down that route.

                • SpaceNoodle@lemmy.world
                  link
                  fedilink
                  arrow-up
                  1
                  ·
                  5 days ago

                  Those can be adequately overcome by a proper controller. The greater challenges are in the physical effects of the actual method, such as CNC burrs and ablation heat spreading.

  • painteddoggie@lemmy.world
    link
    fedilink
    arrow-up
    15
    ·
    6 days ago

    Besides the taxes of it all, are we hiring tons more customs agents to process all of these shipments that used to be exempt? Besides paying more for the item, it is going to take waaaaaaaaay longer to receive an item like this now as well.

    • ExLisperA
      link
      fedilink
      arrow-up
      3
      ·
      6 days ago

      People will order way less so it will even out?